Before Installing And Using The Cloth Guide Roller, Its Static Balance Should Be Corrected

Before installing and using the cloth guide roller, the static balance should be corrected, and no more important phenomenon should be allowed. It is mainly powered by electricity or compressed air to assemble proper derusting assembly, and carry out reciprocating behavior or reverse behavior to comply with the derusting requirements of various places. Fag split spherical roller bearings and ina split cylindrical roller bearings are used to drive the rollers. Shot blasting treatment This is the impact of high-speed iron shots (or projectiles of other materials) thrown by the impeller operating high-speed torsion shot blaster. It rubs against the overview of the parts being cleaned to achieve the purpose of rust removal.

The roundness, taper and radial runout of the working surface of the cloth guide roller must be strictly controlled. 6. Complete the assembly drawing and department parts drawing. However, high vibration values do not necessarily reflect bearing problems or bearing damage. In addition, f’is also provides general training and consulting services for bearing installation and condition monitoring.

The cloth guide device of the stainless steel cloth guide roller is: during the cloth feeding process, when the cloth edge shifts left and right, the edge detection cloth guide device can make the first section of rail follow the cloth edge to move left and right to ensure that the fabric is correctly needled. The infrared edge automatic adjustment device used by the cloth guide roller is composed of two infrared sensors (probes), one controller and two sets of drivers. The working principle of the cloth guide roller is: when the cloth edge is in the position of the infrared probe or left or right, the infrared amplifier outputs the corresponding positive signal or negative signal. The signal is processed by the controller to drive the motor of the driver to make the output shaft of the driver rotate forward or reverse , The rack and pinion mechanism drives the guide rail to move left and right, so that the cloth edge returns to the middle position of the probe. The device has strong anti-interference ability, almost no requirements on the color and thickness of the fabric, high sensitivity, low energy consumption, and adjustment range width. . Guide rail: The tenter guide rail is formed by folding 6mm steel plate. The groove and the chain are lined with wear-resistant steel plates. The guide rail and the needle clip are equipped with special graphite strips. No lubricant is needed. The life of the graphite lining strip is 7200. Over hours, it can be replaced after being worn.　　

There are many properties of rubber rollers, and the difference in performance materials also greatly affects the choices of some users. It has more than 20 years of experience in manufacturing, strong technical force, sophisticated processing equipment, and complete testing methods. The material properties of the rubber roller are divided into a variety of types, and the following two will give you a brief introduction.

Medium resistance performance: This coefficient index is very important: some rubber rollers need to be used under immersion liquid conditions, so before the formulation design, it should be understood in which medium to use, acid resistance, alkali resistance, high temperature resistance, corrosion resistance, resistance Wear, the performance of various rubbers is outstanding in the raw materials and formulation of rubber is very particular.