How To Maintain The Inflation Shaft In Winter?

Everything needs maintenance to extend its life. People also need to maintain health. In fact, the maintenance of the inflation shaft is very simple, because the life of the airbag itself in the inflation shaft is very long, so the probability of damage to the inflation shaft itself is very small. This not only reduces the downtime in the production process, but also greatly reduces the number of defective products, thereby not only reducing the production cost, but also increasing the service life of the inflation shaft.

First, every time you use the air-expansion shaft, you should handle it gently and never throw it away, otherwise it will cause the inflatable shaft parts to fall. Secondly, in the process of use, it must be combined with the air humidity. If the humidity is too high, the airbag inside the air shaft will be wet, which will cause the air shaft to be corroded.

Shafts

Then, during use, if the nut of the inflation shaft is found to be loose, tighten it in the fastest time, otherwise some parts will fall through the airbag and cause delays.

After the inflation shaft is used, the air inside the inflation shaft is discharged, so that the inflation shaft is always in the expanded state, the loss of the inflation shaft is reduced, and the service life of the inflation shaft is prolonged. These are the most basic maintenance. If you don't use it often, it is recommended to do it once a month to ensure that it is used properly.

Things to be aware of when installing an inflatable shaft:

First, understand the special tools required for the construction of the inflatable shaft device and master the application methods.

2. During the process of laying the device, the insulation of the air-expansion shaft should be measured frequently, and the problem should be dealt with in time.

Third, understand the supporting accessories of the inflatable shaft, as well as the equipment and application methods of each accessory.

4. After the air-expansion shaft is laid, if there is no center joint, the terminal can be directly used. If there is a center joint, the center joint should be made first, otherwise it will increase the check phase and other troublesome work.

5. Understand the construction drawings and site conditions, and formulate specific construction plans.

Sixth, in the process of laying the air shaft, or after the laying device is good, it is necessary to strictly prevent the electric welding faucet wire from being dragged or bumped on the inflation shaft.

7. Understand the structure, function and characteristics of the inflation shaft, and understand the type, specifications, varieties and customary places of the inflation shaft.

8. The copper sheath of the inflatable shaft can be used for grounding and it is necessary to ground.

Nine, be proficient in the way of laying the air shaft, the method, method and technology of the air shaft, understand the matters needing attention in the construction, such as the zigzag radius of the air shaft, the placement of the laying, how to enter and exit the distribution box, the cabinet, how to Pay attention to eliminating eddy currents.