Magnetic Powder Brake Durability And Heat Capacity

The durability and thermal capacity of the magnetic powder brake, whether the load of the magnetic powder brake is appropriate has a great impact on its durability, this brake can also be used under continuous slip. The heat generated by the slip causes the temperature of the magnetic powder brake to increase continuously, which affects its working ability. Under normal circumstances, the surface temperature of the magnetic powder brake is controlled to be below 100 degrees Celsius. When the loading capacity of the magnetic powder brake is found to be downloaded, the magnetic powder should be replaced.

Magnetic powder is a consumable. Magnetic powder is a necessary material for magnetic powder brakes. Torque transmission is mainly performed by magnetic powder. The service life of the magnetic powder will be affected by factors such as quality, load, working time, and temperature. If the magnetic powder is not used for the expected time, there must be a reason.

How to install magnetic powder brake correctly
1. When installing the magnetic powder brake, please adjust the suction gap to plus or minus 20% of the specified value on the machine.

Second, while using the frame on the machine side to maintain the lead, it is also necessary to make a reliable connection using a terminal board and the like.

3. When using it in a place with a lot of dust, please put all the magnetic powder brake into the box.

Fourth, please keep the bracket light, and do not use magnetic powder brake bearings to withstand excessive pressure.

Fifth, considering the thermal expansion and other factors, please select the thrust of the installation shaft below 0.2MM.

6. Please use the magnetic powder brake without moisture, oil, etc., if the friction part is covered with moisture, oil, etc., the friction torque will be greatly reduced, and the braking sensitivity will also be deteriorated. In order to avoid use In these cases, please add a cover.

7. For the screws used for assembly, please use spring metal sheet, adhesive, etc. to prevent slack.

8. The size of the long shaft used to install the magnetic powder brake shall use the specifications of JIS0401 H6 or JS6.