The Working Principle Of Crane Carriage Correction System

1. Display: The photoelectric sensor records the specific wheel position, passes through the transmission cable, and transmits it to the control system. After system calculation and detection, the result is sent to the display system. The display system displays the specific position of the cart and the deviation distance of the legs;

2. Detection offset: The control system refers to the left and right behavior of the cart. When the cart is traveling to the left, the two legs are offset. The faster outrigger transmits more data, and the system defines that the outrigger is ahead and This leg is displayed; when traveling on the right, the two legs are offset, and the data transmitted by the faster leg is smaller, and the system defines that the leg is ahead and displays this leg;

3. Deviation correction: When the two legs are offset and reach the user preset deviation, an alarm will be generated and the control system will output the corresponding offset signal, which will cut off the faster outrigger multi-stage speed. After the deviation of the two legs reaches the end of the correction requirements, both outriggers will return to the original Run at normal speed. In case of special circumstances, when the deviation reaches 3/1000 of the span of the cart, the control system will cut off the operation of the cart, realize the stop, and perform manual correction, so that the cycle can achieve the correction effect.