Fully-automatic Correction Device Characteristics

Most of the software of a correction device system is a displacement sensor to check the position of the amorphous strip, and compared with the given quantity analysis. If there is a deviation, the electric actuator is required to correct the deviation until it is within the prescribed quantity analysis. Because the deviation of the management center cannot be accurately measured, the edge of the raw material is generally used as the standard for manipulating data signals. Full-automatic rectification device automatic control system The commonly used experimental amorphous strip is a roll of toilet paper for copying, with a width of 220mm, which bears a small support force and does not allow wrinkles and rolls. The amorphous strip is passed from the unwinding roller 1 through the middle guide roller 3 to the winding roller 6, and the winding roller is driven by a DC brushless motor 7 with infinitely variable speed. The magnetic powder clutch 2 is loaded so that the amorphous ribbon has a certain supporting force, and the size of the supporting force is infinitely adjusted by the exciting current released to the magnetic powder clutch. The lateral deviation of the amorphous strip in the transmission is checked by the photoelectric switch 4, resulting in a telecommunication network that is proportional to the offset.



Advantages of a fully automatic correction device

Its reasonable configuration, strong tolerance of new and old buffer rollers, low frictional resistance of the correction device, reduced driving force consumption, reliable posture, reflects dexterity. It relies on the transmission belt to drive the driving force for long-term full-automatic continuous correction, suitable for extreme nature Not working in environmental work. Not behind, the goods are durable and easy to repair. The transmission belt can be centered from beginning to end; because the machine and equipment use high-precision polyurethane energy-consuming buffer rollers developed by the company's independent products, which greatly increases the life of the belt conveyor, the buffer rollers not only have pressure resistance In addition to high strength, strong airtightness, flame retardant antistatic, anti-corrosion, light weight, low friction, long service life and other characteristics, its bearing capacity is twice as high as that of the same industry. Under the same conditions, its friction and corrosion resistance The characteristics are about 10 times higher, and the anti-pollution and moisture-proof performance is improved by about 15% and 50% in the same industry.



Leading role of automatic correction device

1: Can use electromechanical controller or hydraulic oil cylinder as drive force.

2: Quickly and accurately carry out precise positioning of the waterproof membrane, and the total width of the applied waterproof membrane reaches 1930mm (76.0 ″).

3: Design scheme of low friction steel ball shaft sleeve and rotating rod.

4: The durable overall design can be continuously applied for a long time, which greatly reduces the need for maintenance.

5: Optional servo motor centerer to increase the setting and linear rate of waterproof coil.

6: All standard FIFE® induction switches and control boards can be applied in heel, center, and line correction devices.

7: There are many different structures and rollers for you to adopt.

8: Optional fixed bracket and tripod.