Slat-type Air-expansion Shaft Is Suitable For Items With Large Inner Diameter

Inflatable shaft matching clamp, suitable for coils with large inner diameter, equipped with safety chuck, can make the folding between the inflatable shaft and the machine easy, save time, effort, and cost. The development of the inflatable shaft is based on the original traditional shaft, and through continuous technological innovation, it has been upgraded to a modern inflatable shaft, which has brought the above relevant mechanical value to a new level.

The slat-type air-expansion shaft mainly uses the principles of expansion and contraction to achieve the expansion of the paper tube by the air-expansion shaft, and then discharge the material after deflation. The hose from Taiwan has good shrinkage performance and is not easy to burst. Suitable for items with large inner diameter of coiled tube.

It is a special rewinding and unwinding shaft, which is a shaft whose surface can be expanded after high-pressure inflation. The shaft whose surface part is quickly retracted after deflation is called an inflation shaft. Only the user needs to prepare the air source, and the air pressure is controlled within the range of 6-8 kg. When the reel core needs to be locked, as long as the inflation handle is inflated against the air nozzle on the inflation shaft, it can be completed. When feeding, press the sliding air core on the air nozzle by hand to deflate. All machines and equipment used for rewinding and unwinding can be applied to the inflatable shaft.

Precautions for installation of inflatable shaft.

1. When installing the inflation shaft, the first thing to determine is that the compressor that controls the air pressure is in a stable state. Install a filter directly between the compressor and the inflation shaft to prevent impurities from clogging the air pipe and causing air leakage. ;

2. The direction of air entry should be vertical to prevent damage to the valve.

3. When venting, you must use standard matching vents. It is forbidden to use sharp hammers and other tools to avoid air leakage.

4. To install a pressure gauge and pressure control device, and the air pressure must be controlled within the range of 3-8kg/cm.

5. When replacing the gas nozzle, a socket wrench must be used. If an internal fault occurs and disassembly and maintenance are required, professional maintenance personnel should be asked not to disassemble it to avoid unnecessary losses.

6. Handle with care to avoid injury to the air valve.