Can The Magnetic Powder Brake Be Used When It On Smoking?

1. Please pay attention to moisture. If the magnetic powder gets wet, the performance will become unstable, so be careful not to let oil or moisture invade the inside. Especially when it is installed in the gearbox, the oil will penetrate into the inside through the shaft, so it should be completely sealed with the film.

2. Please pay attention to the surface temperature. The maximum surface temperature caused by continuous operation is 90 degrees or less during operation. When the value exceeds this value, the durability is greatly reduced. Be sure to use the above-mentioned limit temperature as the standard, and be sure to keep it within the allowable sliding work rate when using it.

3. The magnetic powder filled between the two groups of units is scattered on one side during transportation or the installation time is too long, and the excitation is not caused by excitation before starting the machine.

4. Due to the low manufacturing precision of the product, the concentricity of the rotor is insufficient, resulting in uneven output torque or jamming.

5. In the production process, the excess of magnetic powder is enclosed.

6. Caused by the use of inferior magnetic powder. 1. Before the official operation or after the device is moved, it must be evenly operated to be officially operated. In this way, a smooth torque can be generated, and the uniform operation mode is as follows: in the non-excited state, the drive side is rotated as fast as possible (after 1800 rpm) for about 1 minute, and the excitation current is set at a rated 1/4 to 1/5, one. On the side of the slewing drive side, on the one hand, open in 5 seconds, close in 10 seconds, and excite the magnet for about 20 times.

7. When choosing to purchase magnetic powder clutch / magnetic powder brake, it is best to choose a product with guaranteed quality.