How The Safety Chuck Works

The safety chuck is a pre-engineered solution for supporting rolls and transmitting torque. The standard safety chuck provides users with an economical and easy to install design. Provides fast, accurate, safe and easy connection and disengagement for frequent movements such as connecting drives and disengagements.
  Working principle: The chuck type intersecting wire cutting machine has a simple structure. When the system is calculated, the chuck is rotated one week as a parameter. The correct degree is measured. Relatively speaking, the roundness requirement of the pipe is also lower, and sometimes the pipe is slightly bent. It can also be cut by adjusting the position of the bracket. When operating, it is very important to pay attention to the adjustment of the position of the bracket at all times to maintain the level of the tube. If this position is not well adjusted, a large cutting error will occur. In addition, there will always be a blind zone near the chuck area that cannot be cut, affecting the yield of the pipe. Generally, small-diameter pipes with a pipe diameter of not more than 600 mm adopt such a structure. The outer chuck can be provided with a corresponding drive card slot and a disengagement card slot. The outer chuck can be provided with a boss. The inner chuck can be provided with a groove suitable for the boss, and the positioning mechanism can be set on the outer card. Positioning spring on the disc. The hydraulic chuck is arranged at the connecting end of the drill pipe of the main shaft, and the reduction transmission mechanism is a first-stage helical gear reduction transmission mechanism, which has a compact structure, can effectively reduce the size of the power head and reduce the weight of the power head; in a further technical solution, the motor The tilt-shaft plunger variable motor can be used to adjust the variable motor displacement to realize stepless speed regulation; the power chuck power chuck power chuck power chuck adopts a normally closed hydraulic chuck, and is designed with a double-stage sealing structure. The sliding seat can be installed in the effective dustproof slot, and the T-shaped block and the claw are installed on the sliding seat by the claw mounting screw. The piston is installed in the chuck body and is coupled with the wedge core sleeve, and the valve body is equipped with the gas distribution at the rear of the chuck body. The ring, the gas distribution ring and the chuck body are sealed by a sealing ring, and the first pipe joint and the second pipe joint are installed on the upper part of the gas distribution ring. A chute is provided on the wedge sleeve. The principle of the disk clamp workpiece is to use a chuck wrench to rotate any of the three bevel teeth on the circumference. Thereby driving the plane thread to rotate and driving the three claws to move together, the function of self-centering clamping workpiece; from the mechanical structure, the three bevel teeth of the chuck have the same function, but after careful inspection, three umbrella teeth are mounted The precision of the workpiece is not the same, and the difference is also large.