Guide Controller Control System Can Change The Correction Speed

A common correction controller control system can be implemented. However, if the material roll speed needs to be changed, and the ordinary corrector can not change the rectification speed, it will lead to the phenomenon that the curling cannot be corrected, the unevenness of the material thickness and various mechanical damages, resulting in the material on the production line. The phenomenon of movement and one-way deviation causes the machining operation in the middle section to be difficult to match, or the movement of the front and rear sections is uneven, resulting in loss of many materials and difficulty in subsequent processing.

The automatic correction controller system is an AC photoelectric correction control system. The system is easy to operate and easy to install. The performance in terms of system response speed, anti-interference and correction accuracy has been significantly improved compared with previous products. The improved wiring method completely avoids the damage of the controller caused by the original wiring error.

The correction controller checks whether the electric eye indicator is normal, and the sensitivity of the electric eye to the motor. Fill the gear contact position with oil (recommended: oil) to maintain lubrication between the wheels and reduce mechanical wear to ensure the precision of the correction.

The correcting controller can measure the actual tension of the coil, and automatically adjust the excitation current of the clutch or brake according to the set target tension and the measured tension to control the tension of the coil. The correcting controller has extremely high tension control accuracy and is suitable for use in applications where the tension control accuracy is high.