Servo Guide Controller EPC-A10/LPC-A12 Drives DC Servo Motor

The servo guiding controller EPC-A10/LPC-A12 drives the DC servo motor. The servo rectification controller has a high speed, high precision and high rate automatic coil processing process, and the control requirements for the lateral position of the coil are getting higher and higher. Equipped with high-performance automatic rectification is the key to improving the production capacity and yield of coils. The coil will produce lateral displacement (running deviation) during the discharge, intermediate section and receiving process, so the correction system can be installed in the above three positions to control the passing position of the coil. The correction system consists of an automatic control system consisting of a controller, an edge detection/detection line sensor, an electric drive, and a correcting mechanism. The correcting sensor detects the relative position of the edge, the line or the color block of the coil, converts it into an electric signal and transmits it to the correcting controller, and the correcting controller compares the signal with the set signal, and according to the deviation amount, the controller outputs a proportional proportional The signal is corrected immediately to the electric drive. Dongguan Taiwan Machine Reducer Co., Ltd. produces magnetic powder clutch, magnetic powder brake, electromagnetic clutch, electromagnetic brake, electromagnetic clutch brake assembly, tension controller, air expansion shaft, safety chuck, motor, electromechanical, reducer, corrector Machine and other transmissions with accessories.
 
Servo guide controller features:
1. The automatic edge-to-edge device is braked with the air-oil pressure connection system. The oil pressure is used to inspect the differential pressure ratio caused by the edge of the material at the inspection port. The signal is transmitted to the induction chamber, and the air source is received by the induction chamber. The system determines the positive and negative values of the differential pressure ratio, and determines the speed and quantity of the left and right outlets.
2. This system is a truly non-contact, contactless power system.
3. This system is needed for the real external power supply power transmission. It does not need any external air pressure and hydraulic power source. The system can be self-sufficient.
4. When one of the oil outlets performs the oil discharge action, adding an oil outlet port will automatically transform into a return oil flow path, causing the pressure rod in the hydraulic cylinder to move.
5. If the hydraulic cylinder and the bar system are installed in the front, middle or rear part of the material when the material travels, the deviation of the deviation of the system is checked, and the effective driving correction can be made. The serpentine action on the production line is not produced.
 
Advantages of the servo guide controller
1. The ability to correct the deviation is strong. Through the swing of the bracket, the transportation with severe deviation has a good correcting effect.
2, easy to install, the installation of the return belt deflector uses the original bolt holes, does not change the original support structure.
3, automatic immediate correction, when the conveyor belt deviation, can automatically and immediately correct the conveyor belt.
4, using the elastic recovery force to correct the deviation, the wear on the edge of the belt is small.
5, the structure is simple and reliable, no maintenance, cost-effective, has a great promotion value.