Slip Shaft Manufacturer Analysis Common Problems And Maintenance Methods

In the process of using the slip shaft, many problems are easy to occur, so we need regular maintenance, only to get better performance protection. The following slip shaft manufacturers will tell you about the common problems of the slip shaft. And maintenance methods.

1. In the process of loading and unloading, firstly, in the case of inflation, all the raised keys are in a sinking state, and then the materials are assembled or unloaded; many manufacturers are because there are some slip rings that are not stuck. Still in a raised state, or vigorously shirking large rolls of material, over time, this action will lead to inflexibility of the partial slip ring, and finally the entire slip unit is scrapped.

2. During the use of the slip shaft, because the slip ring and the shaft friction will produce a certain amount of heat, this is a normal phenomenon, but if the heat is excessive, this is an abnormal phenomenon, and the excessive heat is caused by the friction. In this case, it is basically going to the back of the large diameter material to appear this situation, because the larger the winding diameter, the greater the tension required, if the air pressure is not large enough, that is, the tension is not large enough, The slip ring is excessively slippery and hot. In the early stage, a lot of dust will appear due to excessive wear of the wool felt. When the wool felt is worn, the airbag is directly worn and the slippery shaft leaks. Therefore, if the fever is excessive, it is necessary to find early treatment and adjust the tension of the machine to prevent more serious situations.

3. During the use of the slip shaft, the operator needs to use the air gun to clean the slip ring to clean the dust and debris.

4. After using the slip shaft for a period of time, it is necessary to loosen the ferrule of the tail of the slip shaft, move it 20mm or more, and then move it in sequence by one slip ring, and also use the air gun to clean dust and debris. Etc., many manufacturers use the slip shaft from the beginning to the end without regular cleaning and maintenance, and finally lead to excessive dust and debris, under the action of the slip ring friction, the shaft slip ring is worn, resulting in a whole slip The difference axis is scrapped or seriously damaged.

5. In the early days, many slitting machines were not equipped with receiving racks. If the winding material was too heavy, and at the moment of unloading, it was completely in a single-sided cantilever state. Under the action of material gravity, the whole slip axis would be slow. Slow deformation, axial bending, and more serious direct axial fracture. Therefore, if your material is too heavy and there is no receiving rack, it is recommended that you take the time to install a receiving rack. While protecting the shaft, it also reduces the workload of the staff and greatly improves the safety.