Use Methods And Maintenance Strategies Of Different Slitters

do you know? Any type of slitter operator must be trained before taking up the job, and must be familiar with the use of different slitters! Equipment performance and general maintenance methods. Non-workers are not allowed to operate at will; do labor protection before starting up, prepare some auxiliary tools and materials for operation (knife adjustment tool, carton required for operation, paper tube, paper knife, tape, etc.) and put it on the machine Suitable location.

Make sure that the cutting machine equipment is in a safe state, turn on the electrical switch, check whether the circuit of the cutting machine is lack of phase, and whether the air path is smooth, test the machine, and check whether the electrical, pneumatic, and mechanical equipment are operating normally. Whether the protective equipment of the slitting machine is perfect. It is necessary to prevent crushing, scratching or bringing into rotating gears, chains, rollers, etc. during operation.

Knife adjustment: adjust the exact knife distance according to the requirements of the operation, pay attention to the direction of the knife edge. If necessary, remove the bottom knife and re-arrange the knife. If the knife has gaps or is not sharp, it should be repaired and replaced. Check the connection between the static elimination facility and the ground wire of the machine to ensure that the static electricity of the material is eliminated during operation. Lay waste paper under the machine to prevent dust absorption.

Pay attention to safety when loading. Push the material to a suitable position for inflation, pay attention to the direction of rotation of the material can not be reversed. Paper-feeding and edging: put the material from unwinding to rewinding according to the direction set by the equipment, and adjust the rectification position to align the edge. When cutting the edge, ensure that there is glue on both sides of the finished product. Be sure to pay attention to the rectification stroke when loading. Be sure to go to the middle of the rectification stroke, and pay attention to one side of the rectification during operation. When the stroke is exceeded, there will be no cut edge to be processed immediately.

Put on the paper tube required by the job on the winding shaft and align the materials. If you need to apply double-sided tape, you must affix the double-sided tape, adjust the appropriate winding tension and unwinding tension, and cut and wind the edge. During the winding process, the quality of the product must be strictly inspected. Inferior products or waste products and other stolen goods or edge strips should not be rolled into the product, and the number of meters should be strictly controlled.

When the machine is stopped and unloaded, it is necessary to hold the material with one hand to pull the product out of the inflation shaft. The material on the painting surface of the photo must be worn with gloves, and no handprints should be left on the product. According to the production requirements, complete the corresponding perfect packaging, including labeling with packaging paper or film, sealing, batch numbering, etc.

After shutdown, turn off the power supply and air source, and perform the necessary cleaning and maintenance on the machine. Try not to scrape the excessive roller as much as possible. The glue on the equipment should be wiped clean with a solvent. If you encounter problems during the operation, in principle, stop processing. If you cannot stop processing, you must slow down and handle carefully.

The above is the industry sharing about slitting machine, I hope you can like it.