Talking about the explanation of the reason why the cutting machine jumps the blade

The slitting machine has stretchability, the tension of the unwinding and unwinding is not well controlled, and the rewinding is as automatic as possible, and the tension is relatively constant. If the cutting machine jumps, there may be no maintenance and maintenance work.

In order to ensure that the slitting machine is always in a good technical state, it can be put into operation at any time, reduce the number of downtime, improve the mechanical integrity rate, utilization rate, reduce mechanical wear, extend the service life of the machine, reduce the cost of machine operation and maintenance Strengthen the maintenance of mechanical equipment.

The maintenance of the slitting machine must implement the principle of "emphasis on maintenance and prevention, mainly on prevention", so that regular maintenance, mandatory implementation, and correct handling of the relationship between use, maintenance and repair are not allowed to be used without maintenance, only repair without maintenance.

The maintenance of the cutting machine must ensure the quality, and it should be carried out one by one according to the prescribed items and requirements. Maintenance items, maintenance quality and problems found during maintenance shall be recorded and reported to the special staff of this department.

Each team must do a good job of maintaining all types of machinery in accordance with the mechanical maintenance regulations and maintenance categories. There can be no unreasonable delay. In special cases, the maintenance can only be postponed after being approved by the instructor, but generally it should not exceed half of the specified maintenance interval. After the above points are achieved, the chance of blade skipping of the slitting machine is greatly reduced.