The Relationship Between Tension Controller And Tension Sensor

When the tension controller is used in the industrial control industry to produce and process products, it is often necessary to control the tension to meet the product requirements. Many customers will have problems with consulting suppliers when working with tension controllers. Will not operate, will not distinguish between tension sensor and tension controller. Not to mention the difference between the characteristics of the tension controller and the tension sensor.

PRE Converting introduces everyone, 1, from the text can be easily distinguished, one is the controller, one is the sensor. 2. Secondly, the analysis of the tension controller from the nature is the high-precision ∑-ΔA/D conversion chip and the MCU with high anti-interference performance as the core, fully taking into account the complexity of the industrial site, with careful hardware and software design to make production and Management is well protected. This product is also suitable for industries requiring tension control such as lithium batteries, textiles, and packaging machinery.

The tension sensor is a load cell and a shaft tension sensor. It is a special sensor for strip tension test. It is combined with LX, LC tension controller, magnetic powder brake and magnetic powder clutch to form a tension control system to realize closed-loop tension control and gravure printing. Widely used in electronic control systems such as machines, slitting machines, and dry machines.

This is the essential difference between them.

1. Before installing the tension sensor, it should be noted that the screw of the tension sensor should not be too long, and the bearing housing is also the same. The screws can not be selected too long, otherwise it is easy to make the spring piece of the tension sensor not work properly, and thus it is not detected. The performance of the tension.

2. When installing the tension sensor, you need to use the side to fix it. You can't use the long screw when fixing. If you use the long screw, the measuring device inside the tension sensor will be damaged easily.

3. When installing the tension sensor, it is necessary to pay attention to the behavior that the tension sensor cannot be subjected to severe impact, otherwise the tension sensor may be easily damaged.

4. After the tension sensor is installed, it is necessary to pay attention to the inspection in all directions to avoid missing parts, or during the installation process, there is no notice that some places are damaged. Only after detailed inspection can the tension sensor be ensured. Work effectively.

The manual tension controller is simple and convenient to use and easy to install. The output is stable, using high-quality components, the product quality is good, the manual tension controller can easily realize the film printing processing, and the winding machine needs to control the tension control of the tension machine. Features: 1. Can achieve constant in the range of 0A~4A

Constant current output 2. The output current can be controlled by the control signal or manually. 3. There is a feedback signal output for detecting the size of the control signal for precise positioning. 4. The output current can be visually displayed. : 1. L, N are AC power input 220V 50/60HZ. 2. GND +24V: Connect magnetic powder clutch and magnetic powder brake. 3.VSET GND: 0~10V external control input voltage (for PLC). 4.ISET: 0~20mA external control input current. 5. AO GND: Set the voltage feedback. 6.PADJ VSET: If using the potentiometer on the panel to adjust, short the PADJ and VSET 7. Width: 180mm Height: 110mm Depth: 135mm.