The Static Balance Of The Cloth Guide Roller Should Be Corrected Before Installation And Use

The static balance of the cloth guide roller should be corrected before installation and use, and there must be no more prominent phenomenon. Mainly use electricity or compressed air as the power to assemble proper rust removal equipment, and carry out reciprocating behavior or reverse behavior to comply with the rust removal requirements of various places. Fag split spherical roller bearings and ina split cylindrical roller bearings are used to drive rollers. Shot blasting treatment This is the impact of high-speed iron shots (or shots of other materials) thrown by the impeller of a high-speed torsion shot blasting machine, which rubs against the surface of the cleaned parts to achieve the purpose of rust removal.

The roundness and taper of the cloth guide roller working surface and the radial runout with the bearing support surface must be strictly controlled. 6 Complete the assembly drawing and department parts drawing. However, a high vibration value does not necessarily indicate a bearing problem or serious bearing damage. In addition, f’is also provides general training and consulting services for bearing installation and condition monitoring.

The cloth guiding device of the stainless steel cloth guiding roller is: when the cloth edge shifts left and right during the fabric feeding process, the edge detection cloth guiding device can make the first section of the guide rail follow the cloth edge to move left and right to ensure that the fabric is needled correctly.

The infrared edge detection automatic adjustment device adopted by the cloth guide roller consists of two infrared sensors (probes), one controller and two sets of drivers.

The working principle of the cloth guide roller is: when the cloth edge is at the infrared probe position or left or right, the infrared amplifier outputs the corresponding positive or negative signal, and the signal is processed by the controller to push the drive motor to make the drive output shaft rotate forward or reverse , The rack and pinion mechanism drives the guide rail to move left and right, so that the cloth edge returns to the middle position of the probe. The device has strong anti-interference ability, almost no requirement for fabric color and thickness, high sensitivity, low energy consumption, and adjustment range width. . Guide rail: The stenter guide rail is formed by folding 6mm steel plate. The groove contacting the chain is lined with wear-resistant steel plate. The guide rail is equipped with special graphite strips at the contact point of the pin. No lubricant is required during use. The life of the graphite lining is 7200 It can be replaced after worn out.