Reasons That Affect The Accuracy Or Parallelism Of The Guide

The front and rear sections of the receiving and sending operations are uneven, causing loss of many materials and subsequent processing difficulties. The speed of the rectifier can be adjusted to low-speed rectification. When the material winding speed is relatively high, the speed of the rectification motor can also be adjusted to high-speed rectification. Adjusting the frequency can adjust the speed of the rectification and correction system. Photoelectric edge-to-line device can solve this problem. Guide system is used for: coating machine, self-adhesive machine, laminating machine, slitting machine, rewinding machine, packaging and printing machinery, etc. The driver of the rectifier has a driving limit. For all the rectifiers, the position deviation within a certain range can be corrected, and this range must be smaller than the drive limit of the driver. The limits of the driver can be adjusted according to the needs of the user. Most drives have a drive limit of plus or minus millimeters.

The deflector obtains signals from sensors placed at appropriate positions on the coil line, processes and amplifies the signals, and then provides them to the actuator; the appropriate output operates the electric drive. The driver thus positions the correction and correction system components and maintains the required state of the coil. The deviation correction controller compares this signal with the set signal, and according to the deviation amount, the controller outputs a corresponding proportional signal to the electric driver for immediate correction. The correction system provides several different detection methods: edge detection, line following or alignment. Its driving system uses low-speed synchronization, variable frequency speed regulation, stepping and servo motor drive. The driving stroke is strictly proportional to the coil offset.

As a supplier of correctors, we can only focus on the position of the edge, line or center line of the coil when it comes out of the probe. Therefore, Youdao Automation Control recommends installing the corrector at the position closest to the key process, but if the end user installs what kind of machine between the corrector and the key process, or the accuracy or parallelism of the roller is not good, it will affect We cannot control the accuracy of the correction system.

The popularity of information technology has greatly changed the external environment facing enterprises. We Wuhan Chuying Technology Development Co., Ltd. also gradually understands the importance of brand awareness. Therefore, Zhengzhou Keso Electro-Hydraulic Equipment is also constantly improving. To bring better competitive advantage. We rely on our ability to innovate and brand packaging, and we believe that we will gradually become a leading company in the correction controller industry. Advanced correction controller technology and excellent service will be the first choice for major correction controller companies.

The correction controller is based on microprocessor technology, and the parameter setting and operation are very simple. EPC-A10, EPC-A12 and other correction controllers are available for selection. It is an ideal choice for correction control during material processing in various width and speed conditions.